Tuesday, October 22, 2019

CAMIS ELECTRONICS
DESIGN & MANUFACTURE OF ELECTRONICS SOLUTIONS

Case Studies

COMPLEX WIRING HARNESSES FOR MOTOR VEHICLES

Camis has 30 years’ experience supplying cable assemblies - from simple cut and stripped wires to value added projects; from reworking far-east produced cord sets to complex vehicle wiring looms. Working with customers drawings, Camis produces bespoke assembly jigs and...

REDESIGN OF SENSING CONTROLS USED WITH AIRPORT BAGGAGE HANDLING CAROUSELS

Camis were invited to offer a replacement for an obsolete sensor device used extensively in baggage handling systems for airport carousels.  The redesign called for a precise 3-axis proximity sensor module housed in a bespoke...

THE DESIGN AND MANUFACTURE OF AN ADIABATIC COOLING SYSTEM MAIN HARNESS & PUMP LOOM

CAMIS engineers have designed a cost effective wiring harness assembly for office desk top air coolers which is now being manufactured and supplied monthly by the CAMIS Looms Division.   

CAMIS LOW PRESSURE OVERMOULD SOLUTION

Suitable for many applications, overmoulding offers a reliable, fast and cost-effective route to market:  • improved product design • increased environmental protection • cable strain relief • eliminated vibration for component stability • reduced manufacturing costs • enhanced aesthetic presentation with a customized...

INNOVATIVE INDUSTRIAL PROJECTS

Camis offers bespoke electrical/electronic product design and production. This can be either developed from a simple customer concept or detailed finalised design. Working with customers from initial feasibility through to prototype/sampling ensures cost-effective in-house...

A SAFETY WARNING DEVICE FOR THE TRAILER INTERFACE COUPLING ON ARTICULATED VEHICLES

Camis Engineers have redesigned a robust 3-sensor safety coupling system for the Fifth Wheel, preventing closure if the kingpin enters at the incorrect height or position.  In a joint venture with a sensor manufacturer, Camis...

AN UPGRADE TO A JOYSTICK CONTROL FOR OFF-ROAD AGRICULTURAL VEHICLES

The customer requirement was for a 5 axis proportional control rather than the existing 3 axis.  The design brief included the use of a smaller enclosure unit and replacing the existing toggle switches with a...